tie rod

1. Adjustable screw type steering gear Tie Rod End Adjusting Sleeve Nut
   可调整式螺旋型转向装置转向拉杆端调整轴筒螺栓
2. The application of steel tie rod can decrease usage amount of steel and make the structure lighter and graceful.
   钢拉杆的应用可以降低工程用钢量，是建造大跨度结构及大吨位码头的重要构件。
3. It has also been proved that the tie rod force ( F) of anchored sheet pile wall would strongly influence soil settlement.
   并求证了拉锚式支护结构的锚固力F对控制支护土体变形的有利影响。
4. Mount the tie rod end on the wheel carrier.
   将横拉杆端安装到车轮托架上。
5. Torquing Tie Rod End Attaching Nut
   拧紧转向拉杆端接合螺帽
6. Analysis of random dynamic response to tie rod of the prestress rolling mill
   预应力轧机拉杆的随机动力响应分析
7. Check the right tie rod joint.
   检查右侧横拉杆接头。
8. Tie Rod End To Steering Knuckle Nut
   转向拉杆端与转向关节螺栓
9. Tie Rod End Adjusting Sleeve Nut
   转向拉杆端调整轴筒螺栓
10. Steering knuckle tie rod end pressure lubricator What welding methods do you use in connecting the plates, frames, and beams?
    转向节横拉杆接头油嘴在焊接钢板，肋骨，甲板横梁时，你们用什么焊接方法？
11. High-durable smart steel tie rod based on FBG absolute measuring technology
    基于光纤光栅绝对测量技术的高耐久智能钢拉杆
12. Taping the thread of tie rod after painting to avoid damage during transportation.
    喷涂后对螺纹进行保护，防止运输过程中发生碰撞。
13. In the double control arm axle, the wheel carrier is supported by two A-frame arms and a tie rod.
    在双控制臂车桥中，车轮托架由两个三角形臂和一个横拉杆来支撑。
14. This can be done through adjusting the length of the tie rod.
    调节前束可以通过调节横拉杆的长度来进行。
15. Steering knuckle tie rod end pressure lubricator Grayioc tubing joint
    转向节横拉杆接头油嘴
16. Cut-off point of tie rod influences toe angle greatly impacted wheels toe angle.
    转向拉杆断开点的位置对车轮前束角的影响很大；
17. The tie rod at each end of the rack connects to the steering arm on the spindle.
    齿条一端连着拉杆，拉杆与车轮轴上的转向摇臂相连接。
18. In general, steel tie rod is perfect combination of strength and beauty and is one kind of most important material in new construction area.
    可以说，钢拉杆是力与美的完美结合，是新型建筑领域的一项重要分支。
19. Press the tie rod end off with a press-out tool.
    用压出工具压出横拉杆端。
20. Drive shaft, Tie rod end assembly, Ball joint, Control arm assembly.
    悬挂球头、拉杆球头、横拉杆、拉杆总成、控制臂总成等。
21. Steel tie rod has certain rigidity that makes the installation more easy and convenient.
    同时钢拉杆本身具有一定的刚度，便于施工安装，其应用更加广泛。
22. A rod, called a tie rod, connects to each and of the rack.
    拉杆，或称为转向拉杆，与摇臂的另一端连接。
23. The hinge joint can move vertically, which can insure there is only tension act on steel tie rod and avoid bending deflection under the force of groundsill and sand stone.
    单向绞沿竖直平面可以发生转动，防止因地基沉降、砂石回填等因素使钢拉杆承受侧向弯矩，确保只承受拉力；
24. Construction technique of back pouring of tie rod arch bridge arch rib steel pipe concrete
    钢管混凝土系杆拱桥拱肋混凝土倒注施工技术
25. In recent years, it has been conducted an intensive study on high strength constructional steel tie rod.
    近年来，我国对高强度建筑钢拉杆进行了大量的应用研究。
26. Formation of Steering Tie Rod Ball Studs by single cold Extrusion
    转向拉杆球头销一次冷挤成型
27. Fracture analysis of intermediate tie rod of well drilling pump
    钻井泵中间拉杆破断分析
28. Technical application and investigation of the high strength constructional steel tie rod
    高强度建筑钢拉杆的应用与研究
29. The manufacture and application of high strength steel tie rod for engineering
    工程用高强度钢拉杆的研制与应用
30. The results showed that the intermediate tie rod was fractured by corrosion fatigue.
    结果表明，该中间拉杆的破断属腐蚀疲劳失效。

noun

1. either of two rods that link the steering gear to the front wheels